Packet capture creates multiple files (one Suppose you name the packet captureįile pcap-file. Packet capture creates one file for each physicalįile creation and storage take place in the following way. You can specify the maximum size of the packet to beĬaptured, up to 1500 bytes. When packet capture is enabled on an interface, the entire packet including the Layer 2 header isĬaptured and stored in a file. Packet capture files, and the file permissions. The captured packets, the maximum file size, the maximum number of To specify the maximum packet size, the filename to be used for storing Use the J-Web configuration editor or CLI configuration editor Tunnel interfaces support packet capture in the outbound direction only. You have configured and applied a firewall filter on the interface in the outbound direction. PIM), packets generated by the Routing Engine are not captured unless The flow software module (protocol packets such as ARP, OSPF, and You can capture all IPv4 packets flowing on an interface in Multilink Frame Relay end-to-end (MLFR), and Multilink Frame Relay Packet capture also supports Multilink PPP (MLPPP), Packet capture supports PPP, Cisco HDLC, Frame Relay, and otherĪTM encapsulations. To capture packets on a PPPoE interface,Ĭonfigure packet capture on the PPPoE logical interface. To capture packets on an ISDN interface, configure packet capture Packet capture is supported on the T1, T3, E1, E3, serial, Gigabit Ethernet, ADSL, G.SHDSL,
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |